Benjamin Moore Studio Finishes Metallic Glaze Copper 620 40
is an acrylic-based glaze designed to produce beautiful copper metallic special effects.Colors Available: Gold 620 10
, Silver 620 20
, Bronze 620 30
, and Pearlescent Tint Base 04*Gloss:
Acrylic LatexRecommended Use:
Destination Paint recommends Benjamin Moore Studio Finishes Metallic
Glaze Copper 620 40
for interior use on previously painted surfaces, including ceilings, walls and trim. Ideal for use wherever a copper metallic finish is desired.Additional Information:*May be tinted with up to 1/2 fl. oz. of Benjamin Moore® Color Preview colorants per quart.
Surfaces to be finished must be clean, dry and free of wax, grease,scaling paint and mildew. Hard, glossy areas should be dulled with fine grit sandpaper to ensure proper adhesion.WARNING!
If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE.
Wear a NIOSH-approved respirator to control lead exposure. Carefully clean up with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead
Apply Benjamin Moore Studio Finishes Metallic
Glaze Copper 620 40
over the base coat color in manageable (3’ x 3’) irregularly shaped sections, being careful to maintain a wet edge between sections to prevent lap marks.Since the final appearance of your project will be influenced by the base coat color and the application technique, experiment first on an isolated area or sample board to be certain the desired effect is achieved. In most faux finishing techniques the application of the glaze with a brush, roller or by spray is not the final step as these application methods do not normally provide the desired texture. In the final step the wet glaze is commonly re-textured with a sponge, lint free rag, plastic bag, pouncing brush or other tool to create a uniform distribution and the finished texture.Note:
Ambient temperature and humidity will affect working time.Thinning/Cleanup
Thinning is unnecessary, but a small amount of water may be added to obtain desired application properties. Never add solvents and only use in conjunction with appropriate BENJAMIN MOORE
products according to label directions.CLEAN UP:
Wash brushes, rollers and other specialty tools in warm, soapy water promptly after painting.USE COMPLETELY OR DISPOSE OF PROPERLY.
Dry, empty containers may be recycled in a can recycling program. Local disposal requirements vary, consult your sanitation department or state-designated environmental agency on disposal options.Environmental & Safety Information
Use only with adequate ventilation. Do not breathe spray mist or sanding dust. Ensure fresh air entry during application and drying. Avoid contact with eyes and prolonged or repeated contact with skin. Avoid exposure to dust and spray mist by wearing a NIOSH approved respirator during application, sanding and clean up. Follow respirator manufacturer’s directions for respirator use. Close container after each use. Wash thoroughly after handling.FIRST AIDEye Contact:
Flush with water for 15 minutes.Skin Contact:
Wash with soap and water.
If you experience difficulty breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately.IN CASE OF SPILL:
Absorb with inert material and dispose of as specified under “Thinning/Cleanup”.
KEEP OUT OF REACH OF CHILDREN Material Safety Data Sheet (MSDS):MSDS 620 EnglishMSDS 620 EspañolTechnical Data Sheet (TDS):TDS 620 English
PROTECT FROM FREEZING
Material Safety Data Sheets available on request from your servicing dealer.