 |
 |
 |
|
Benjamin Moore Eco Spec Waterborne Interior Latex Primer 372 is a low odor, zero VOC, 100% acrylic interior latex
primer sealer
with spatter resistant properties. Ideally suited for commercial,
facility management, and residential applications. Benjamin Moore Eco Spec Waterborne
Interior Latex
Primer 372 does not have the odor of
conventional primers which contain ingredients known as volatile Organic
Compounds (VOC's).
Always use Benjamin Moore Eco Spec Waterborne
Interior Latex
Primer 372 as a first coat when a
low-odor, VOC free primer/finish system is required.
Colors Available: White, Deep Base
Gloss: Primer
Cleanup: Water
Resin Type: 100% Acrylic Latex
Recommended Use: Interior
Recommended For: Destination Paint recommends Benjamin Moore Eco Spec Waterborne
Interior Latex
Primer 372 for priming and sealing new or previously painted drywall, composition board, wood, concrete, plaster, and other porous surfaces when a low odor, solvent free primer/finish system is desired.
Surface Preparation
Surfaces to be primed must be clean, dry, and free of wax, grease, dust, mildew, water soluble materials and scaling paint. Glossy areas should be dulled. Apply Benjamin Moore Eco Spec Waterborne
Interior Latex
Primer 372 before and after filling nail holes, cracks, and other surface imperfections. Sand when dry. New plaster or masonry surfaces must be cured 30 days before priming.
For best hiding results, tint Benjamin Moore Eco Spec Waterborne
Interior Latex
Primer 372 to the approximate shade of the finish coat, especially when a significant color change is desired.
A primer is not required on previously painted surfaces in good condition and similar color.
Benjamin Moore offers a number of specialty primers for use over difficult substrates such as bleeding woods, grease stains, crayon markings, hard glossy surfaces, galvanized metal, or other substrates where paint adhesion or stain suppression is a particular problem. Destination Paint can recommend the right problem-solving primer for your special needs.
WARNING! If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Carefully clean up with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
Application
Stir thoroughly before use. Apply one or two coats. For best results, use a Benjamin Moore custom-blended nylon/polyester brush, Benjamin Moore roller, or a similar product. This product can also be sprayed. Apply generously, using short overlapping strokes, brushing or rolling from unpainted areas into painted areas. Avoid excessive brushing and rolling. Let dry before touching up any missed spots. Do not apply when air or surface temperatures are below 50° F (10° C).
Spray, Airless: Fluid Pressure — 1,500 to 3,000 PSI; Tip — .013 - .017 Orifice
Thinning/Cleanup
Thinning is unnecessary, but if required to obtain desired application properties, a small amount of clean water may be added. Never add other paints or solvents.
Cleanup: Wash brushes, rollers, and other painting tools in warm soapy water immediately after use. Spray equipment should be given a final rinse with mineral spirits to prevent rusting.
USE COMPLETELY OR DISPOSE OF PROPERLY. Dry, empty containers may be recycled in a can recycling program. Local disposal requirements vary; consult your sanitation department or state-designated environmental agency on disposal options.
Environmental, Health & Safety Information
Use only with adequate ventilation. Do not breathe spray mist or sanding dust. Ensure fresh air entry during application and drying. Avoid contact with eyes and prolonged or repeated contact with skin. Avoid exposure to dust and spray mist by wearing a NIOSH approved respirator during application, sanding and clean up. Follow respirator manufacturer’s directions for respirator use. Close container after each use. Wash thoroughly after handling.
FIRST AID: In case of eye contact, flush immediately with plenty of water for at least 15 minutes; for skin, wash thoroughly with soap and water. If symptoms persist, seek medical attention. If you experience difficulty breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately.
IN CASE OF SPILL: Absorb with inert material and dispose of as specified under Thinning/Cleanup.
KEEP OUT OF REACH OF CHILDREN
PROTECT FROM FREEZING
Refer to Material Safety Data Sheet for additional health and safety information.
MSDS:
MSDS
372 (English)
TDS:
TDS
372 (English)
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features At A Glance
Benjamin Moore Eco Spec Waterborne Interior Paint Eggshell 374
- Minimal Odor
- Zero VOC’s
- Quick return to service
- 100% Acrylic
- Dries quickly to a beautiful eggshell finish with the washability of
a semi-gloss
- Spatter-resistant
|
|
|
|
|
|
|
